As developed within this pap around the surface of a dielectric layer, streamer and glow corona erated alternatively. The outcomes show that adding a silver laye the dielectric layers prevents discharge in the contact surf dielectric layer for the duration of 0.5 mm discharge. In the similar time, tSupplementary Materials: The following are obtainable on the net at https://www.mdpi.com/article/10 .3390/mi12111287/s1, Figure S1. Main circuit of IGBT inverter. Figure S2. PWM modulation circuit. Figure S3. Drive circuit of IGBT. Figure S4: Corresponding ICCD photos of SDBOR. Author Contributions: Conceptualization, P.L. and Y.S.; methodology, Y.S.; validation, P.L.; investigation, Z.Z.; writing–original draft preparation, P.L.; writing–review and editing, Y.S.; project administration, Y.S. All authors have read and agreed towards the published version in the manuscript. Funding: This research received no external funding. Conflicts of Interest: The authors declare no conflict of interest.A novel SL-DBD ozone reactor was developed within this paper. By placing a silver layer on the surface of a dielectric layer, streamer and glow corona discharge had been stably generated alternatively. The results show that adding a silver layer amongst the electrode plus the dielectric layers prevents discharge in the speak to surface of your electrode as well as the dielectric layer in the course of 0.five mm discharge. At the identical time, the electric field intensity within the discharge gap is enhanced. SL-DBD reactor can correctly create ozone using a concentration of as high as 150 g/m3 . The spectral peak of O at 777 nm in SL-DBD is improved to 0.96, compared with 0.61 inside a reactor with a streamer only. Compared with other reactors, the concentration of ozone generated by the novel reactor is enhanced by ten times. The concept of putting a layer of silver between the electrode and the dielectric layer is definitely an helpful approach for improving the electric strength for ozone synthesis and shows superior stability in an 8 h durability test.
applied sciencesArticleCarbon Dioxide Decomposition by a Parallel-Plate Plasma Reactor: Experiments and 2-D ModellingAli PX-478 Inhibitor Barkhordari 1, , Saeed Karimian 2 , Antonio Rodero three, , Dorota Anna Krawczyk 4 , Seyed Iman Mirzaei five and Amir Falahat13Faculty of Physics, Shahid Bahonar University of Kerman, Kerman 7616913439, Iran Department of Physics, Vali-e-Asr University of Rafsanjan, Rafsanjan 7718897111, Iran; [email protected] Division of Physics, University of Cordoba, E-14071 Cordoba, Spain Department of HVAC Engineering, Bialystok University of Technologies, 15-351 Bialystok, Poland; [email protected] Division of Plasma Engineering, Graduate University of Sophisticated Technology, Kerman 7616913439, Iran; [email protected] Division of Pilotage, Mahanair UAST University of Kerman, Kerman 7616913439, Iran; [email protected] Correspondence: [email protected] (A.B.); [email protected] (A.R.)Featured Application: This study is aspect of a project which aims to investigate the -Irofulven Purity & Documentation applicability of plasma technologies to air high quality. This paper describes the development of a new plasma reactor for CO2 decomposition that functions at atmospheric stress with AC power. Results for pure CO2 are presented that elucidate the main mechanisms causing splitting of this molecule within the created reactor.Citation: Barkhordari, A.; Karimian, S.; Rodero, A.; Krawczyk, D.A.; Mirzaei, S.I.; Falahat, A. Carbon Dioxide Decomposition by a Parallel-Plate Plasma Reactor: Experiments and 2-D.